6 Steps For Efficient Gun Cleaning

6 Steps For Efficient Gun Cleaning

These are the 6 most crucial steps to gun cleaning:

Step 1. ALWAYS be sure the gun is unloaded and pointed in a protected direction!

Step 2. Carefully take gun apart, ensuring to maintain track of all parts. Please reference your owners handbook for detailed instructions on find out how to disassemble weapon. For most over/unders, when the motion is closed, you remove the forestock (wooden part where your entrance hand goes underneath the barrel) by flattening on the lever on the forestock. With the forestock off, you open the action of the gun and pull up and forward on the barrels (watch out to not let the barrels fall off the gun and to the ground as soon as the action is open). You now have three distinct items, the receiver (stock and rifle cleaner trigger assembly), the barrels, and the forestock. (Additionally, reference our gun cleaning video to follow alongside visually).

Step 3. Clean your weapon with a solvent (similar to Hoppe's 9). Inside the barrels, use a bore brush or a rod with a patch with solvent utilized to the patch. (favorable pushing from the breach to the front of barrels (the identical direction the shot/slug travels). Then use a clean dry patch and push that patch by the barrels. Continue this alternating process using clear patches (first with solvent after which with out) until the patches now not come out dirty. Use a toothbrush with solvent to scrub other metal parts of gun to remove accumulated residue/deposits/"gunk".

Step 4. Remove any remaining solvent from surfaces. Wipe down the firearm and all the components to remove any residual solvent (which if left on metal may be harmful).

Step 5. Wipe down metal parts with light coat of oil/lubricant/rust inhibitor. To guard the firearm and assist it operate properly, wipe down metal components with a light coat of gun oil or lubricant corresponding to silicone or RemLube by Remington. Use the lubricant/oil sparingly. Just a little goes a protracted way. If the storing the gun, try not to go away fingerprints on it. While the fingerprints will probably not do anything to effect the perform of the gun, they can be unsightly and the oils in your skin could mar the finish of the metal.

Step 6. Reassemble weapon and verify that it's functioning properly. Holding the receiver horizontal and with the barrels at a 45 degree angle to the ground, slide the barrels down onto/into the receiver until the "hook" on the bottom of the barrel(s) catches in the receiver. Lift up on the front of the barrels till they lock into place. Now reattach the forestock. With the small latch on the forestock open, slide the forestock into place and easily shut the latch. Then open the breach of the gun and close it again to ensure reassembly was performed correctly. All elements should move smoothly with none excess liquids/oils/and many others seen on any half(s) of the gun. Do NOT use undue power on the weapon. Chances are if it's important to use a lot (if any) muscle, you're doing something incorrectly.