6 Steps For Effective Gun Cleaning

6 Steps For Effective Gun Cleaning

These are the 6 most important steps to gun cleaning:

Step 1. ALWAYS make sure the gun is unloaded and pointed in a safe direction!

Step 2. Rigorously take gun aside, ensuring to maintain track of all parts. Please reference your homeowners guide for detailed directions on the best way to disassemble weapon. For many over/unders, when the action is closed, you remove the forestock (wooden part the place your entrance hand goes beneath the barrel) by pulling down on the lever on the forestock. With the forestock off, you open the motion of the gun and pull up and forward on the barrels (watch out not to let the barrels fall off the gun and to the ground as soon as the motion is open). You now have three distinct items, the receiver (stock and set off assembly), the barrels, and the forestock. (Additionally, reference our gun cleaning video to comply with along visually).

Step 3. Clean your weapon with a solvent (resembling Hoppe's 9). Inside the barrels, use a bore brush or a rod with a patch with solvent applied to the patch. (wantable pushing from the breach to the entrance of barrels (the identical direction the shot/slug travels). Then use a clean dry patch and push that patch through the barrels. Proceed this alternating process using clear patches (first with solvent and then with out) until the patches not come out dirty. Use a toothbrush with solvent to wash other metal parts of gun to remove accumulated residue/deposits/"gunk".

Step 4. Remove any remaining solvent from surfaces. Wipe down the firearm and all of the elements to remove any residual solvent (which if left on metal can be harmful).

Step 5. Wipe down metal parts with light coat of oil/lubricant/rust inhibitor. To protect the firearm and assist it operate properly, wipe down metal parts with a light coat of gun oil or lubricant reminiscent of silicone or RemLube by Remington. Use the lubricant/oil sparingly. A bit goes a long way. If the storing the gun, strive to not leave fingerprints on it. While the fingerprints will probably not do anything to effect the perform of the gun, they are often unpleasant and the oils on your skin might mar the end of the metal.

Step 6. Reassemble weapon and verify that it is functioning properly. Holding the receiver horizontal and with the barrels at a 45 degree angle to the ground, slide the barrels down onto/into the receiver until the "hook" at the backside of the barrel(s) catches within the receiver. Lift up on the front of the barrels till they lock into place. Now reattach the forestock. With the small latch on the forestock open, slide the forestock into place and easily shut the latch. Then open the breach of the gun and close it again to ensure reassembly was done correctly. All elements should move smoothly without any excess liquids/oils/and so forth seen on any part(s) of the gun cleaning solvent. Do NOT use undue power on the weapon. Chances are if you need to use much (if any) muscle, you are doing something incorrectly.